source : yahoo.com

## Physics help !!? | Yahoo Answers

R = V/i = 10/0.5 = 20Ω

V(t) = 10cos50πt = 10cos9000t where 9000t is in degrees because 50π rads/sec * 180°/π radians =9000

i(t) = 0.5cos50πt = 0.5cos9000t where 9000t is in degrees

At 15ms V = -7.07 and i = -0.3536A and they are exactly in phase with each other. 9000*15e-3 = 135°

Physics 2 – Chapter 15: Alternating-Current Circuits | Quizlet – 1. Draw the phasors for voltage across each device: resistor, capacitor, and inductor, including the phase angle in the circuit. 2. If there is both a capacitor and an inductor, find the net voltage from these two phasors, since they are antiparallel.You use Kirchhoff's current law and sum the two phasor currents together to get the total current. Say we take the 15 A current as the reference and assume the 10 A current lags by 30ºAnd at the end, voltage and current relationship between the basic circuit elements like resistor, inductor, and capacitor has been explained using phasor diagram.

How to determine the magnitude of the current drawn by the… – Draw the resistor?s voltage and current phasors at t=15ms. Draw the vectors with their tails at the origin. The orientation of your vectors will be graded.This preview shows page 13 – 23 out of 60 pages. Draw the current and voltage phasors. Phase Shift of a Capacitor • The voltage lags the current by 90° or: • The current leads the voltage by 90° • At a particular time t , the argument of the current will…Resistors in Electric Circuits (3 of 16) Voltage, Resistance & Current for Parallel Circuits. Step by Step Science. Equivalent Resistance of Complex Circuits – Resistors In Series and Parallel Combinations. The Organic Chemistry Tutor.

Phasor and The Phasor Diagram in AC Circuits Explained – •Introduction •Sinusoids •Phasors •Phasor Relationships for Circuit Elements •Impedance and Admittance •Kirchhoff'sLawsintheFrequencyDomain •Circuits driven by sinusoidal current or voltage sources are called ac circuits. If the current through the resistor is.If I have a single 270 ohm resistor connected in a circuit to a 3.3V 50mA power supply, how can I measure the voltage and current for the resistor? I'm familiar with Ohm's law V=IR, where V is the voltage differential, but what is the differential for a resistor?Physics Scientists and Engineers. FIGURE EX32.5 shows voltage and current graphs for a resistor.a. a. What is the emf frequency f ? b. What is the value of the resistance R? c. Draw the resistorâ€™s voltage and current phasors at t = 15 ms.

**Consider a series RC circuit as in the figure below for which R = 1.00 MΩ, C = 5.00 µF, and ε = 30.0** – .